Details

With the new Reveal models, the cabinets have been further braced and refined to provide the most rigid platform possible for the new driver designs. Securely attached to the solid baffle, with no less than 10 hex socket countersunk-head screws, an all-new bass driver performs with significantly reduced distortion. Magnetic circuit flux control rings and extensive Klippell™ based symmetry analysis has made this performance improvement possible and the new driver provides tight, punchy and controlled bass response with a clean and open mid range for superb vocal intelligibility.

Features

From the front:

• 40mm MDF sculpted baffle – stiff, heavy and rigid and minimises diffraction.
• Recessed drive units flush with the baffle surface – minimises diffraction.
• New tweeter has wide band design extending the amplitude response beyond 20kHz audibility to 50kHz to correct the phase response from 8kHz to 20kHz within the audible band. This preserves the harmonic structure of sounds and the stability of the stereo image.
• Smooth tweeter faceplate contours prevent diffraction and cavity effects.
• 10 point fixing maximises contact between drive unit and baffle.
• New design bass units have aluminium flux control rings around the voice coils and copper caps on the pole pieces – linearises the voice coil motional impedance to reduce non linear (3rd order) distortion products caused by varying voice coil inductance. (Except R5A).
• Bass unit development using Klippell™ analysis equipment to minimise offsets and linearise the suspension components.

From the side:

• 18mm MDF cabinet construction provides stiffness and minimises colouration.
• Internal construction braces the sides and rear of the cabinet against the rear of the bass driver to provide a rigid reactive mass for the moving cone assembly. Ensures fast tight bass response and clear midrange.
• Front baffle and rear panel tongued and grooved into the cabinet as a mechanical interlock for safety if wall mounted.
• From the rear:
• Simple foolproof gold plated terminal panel. No degradation due to bi-wire links in the HF signal path.
• OmniMount™ friendly fixing points for wall mounting.

Specifications

• Frequency Response (1): 63Hz to 51kHz
• Recommended Amplifier Power: 50 to 100W @ 8 ohm
• Power Handling Average RMS (2): 50W
• Power Handling Programme RMS: 100W
• Nominal Impedance: 6 ohm
• Sensitivity (3): 90dB for 1W at 1m
• Distortion: <0.6%
• Crossover Frequency: 2.9kHz
• Dispersion: (@-6dB) 90 degrees
• DRIVE UNITS
  LF/MID: 165mm (6”) multi fibre paper pulp cone
  WideBand HF: 25mm (1”) titanium dome, neodymium magnet system.
• Shielded: Yes
• CABINET Type: Optimised bass-reflex loaded
• Construction: MDF cabinet and front baffle, Tongue and groove front and back
• Finish: Grey cabinet, Maroon painted baffle
• Shipping dimensions (HxWxD): 622mm x 287mm x 440mm (24 1/2” x 11 1/4” x 17 3/8”)
• Shipping weight: 16 kg (35.3lbs)
• (3) Average over specified bandwidth for half space environment.