Shure SLX14/85 Lavalier Wireless System Details

• Operating Range Under Typical Conditions
  100m (300 ft.)  Note: actual range depends on RF signal absorption, reflection, and interference
• Audio Frequency Response (+/– 2 dB)
  Minimum: 45 Hz
  Maximum: 15 kHz
  (Overall system frequency depends on microphone element.)
• Total Harmonic Distortion (ref. +/– 38 kHz deviation, 1 kHz tone)
  0.5%, typical
• Dynamic Range
  >100 dB A-weighted
• Operating Temperature Range
  –18°C (0°F) to +57°C (+135°F)
  Note: battery characteristics may limit this range
• Transmitter Audio Polarity
  Positive pressure on microphone diaphragm (or positive voltage applied to tip of WA302 phone plug) produces positive voltage on pin 2 (with respect to pin 3 of low impedance output) and the tip of the high impedance 1/4-inch output.

• Audio Input Level
  -10 dBV maximum at mic gain position
  +10 dBV maximum at 0 dB gain position
  +20 dBV maximum at -10 dB gain position
• Gain Adjustment Range
  30dB
• Input Impedance
  1 MÙ
• RF Transmitter Output
  30 mW maximum (dependent on applicable country regulations)
• Dimensions
  108 mm H x 64 mm W x 19 mm D (4.25 x 2.50 x 0.75 in.)
• Weight
  81 grams (3 oz.) without batteries
• Housing
  Molded ABS case
• Power Requirements
  2 “AA” size alkaline or rechargeable batteries
• Battery Life
  >8 hours (alkaline)

• Audio Input Level
  +2 dBV maximum at -10dB position
  -8 dBV maximum at 0dB position
• Gain Adjustment Range
  10dB
• RF Transmitter Output
  30 mW maximum (dependent on applicable country regulations)
• Dimensions (including SM58 cartridge)
  254 mm x 51 mm dia. (10 x 2 in.)
• Weight
  290 grams (10.2 oz.) without batteries
• Housing
  Molded PC/ABS handle and battery cup
• Power Requirements
  2 “AA” size alkaline or rechargeable batteries
• Battery Life
  >8 hours (alkaline)

• Dimensions
  42 mm H x 197 mm W x 134 mm D (1.65 x 7.76 x 5.28 in.)
• Weight
  816 g (1 lb. 13 oz.)
• Housing
  Galvanized steel
• Audio Output Level (ref. +/– 38 kHz deviation with 1 kHz tone)
  XLR connector (into 600 Ù load): –13 dBV
  1/4 inch connector (into 3000 Ù load): –2 dBV
• Output Impedance
  XLR connector: 200 Ù
  1/4 inch connector: 1kÙ
• XLR output
  Impedance balanced
  Pin 1: Ground (cable shield)
  Pin 2: Audio
  Pin 3: No Audio
• Sensitivity
  –105 dBm for 12 dB SINAD, typical
• Image Rejection
  >70 dB, typical
• Power Requirements
  12–18 Vdc at 150 mA, supplied by external power supply