Home > Recording > Signal Processors > Line Utility >

  Shure A15HP High Pass Filter

Shure A15HP
Shure A15HP
 
List Price: $56.00
Our Price: $49.00


Availability: Usually Ships in 24 Hours
Product Code: 9999-12401

 

Shure A15HP High Pass Filter

Shure A15HP High Pass Filter is a balanced XLR in-line filter that reduces low frequencies below 100 Hz. It passes mid and high frequencies while reducing low frequencies.

Shure A15HP High Pass Filter Details

Shure A15HP High Pass Filter is a balanced XLR in-line filter that reduces low frequencies below 100 Hz. It passes mid and high frequencies while reducing low frequencies. Shure A15HP High Pass Filter helps to eliminate electrical and mechanical noise in an audio system such as 60Hz electrical hum from AC power lines, low-frequency rumble caused by wind noise or air conditioning system, and stage/floor noise transmitted to a microphone through the microphone stand. Shure A15HP High Pass Filter affects frequencies below 100 Hz. When connected to the microphone input on a typical mixer (800 ohms impedance or higher), Shure A15HP High Pass Filter reduces low frequencies by 12dB per octave. Female XLR to male XLR connector.


Shure A15HP High Pass Filter Features


  • Balanced XLR in-line filter that reduces low frequencies below 100 Hz
  • Helps to eliminate electrical and mechanical noise in an audio system
  • Female XLR to male XLR connector

Shure A15HP High Pass Filter Specifications


  • Manufacturer: Shure
  • Product: A15HP High Pass Filter
  • Frequency Response: Flat above rolloff point; -0.5 dB maximum at 1 kHz
  • Impedance: Designed for 150 ohm rated microphones and inputs
  • Distortion: 2.5% maximum (100 mV input, open circuit output)
  • Connectors: Input: XLR female, Output: XLR male
  • Case: Full magnetic shield, steel with gray enamel finish
  • Dimensions: 19 mm (3/4 in.) diameter; 114 mm (4 1/2 in.) long

Shure A15HP High Pass Filter Downloads



Click here to view all Shure Products