In Line Cable Mounted Amplifier. The RODE D-PowerPlug is effectively a ‘Turbo Charger’ for Dynamic microphones! Featuring an instrumentation grade pre-amplifier circuit, D-PowerPlug will turn any standard dynamic microphone into a high level electronically balanced output device. Using conventional microphones with long multicore cables results in a dramatic loss of signal strength, and of course sound quality due to cable resistance and capacitance. Powered by standard P48V, D-PowerPlug can drive cables in excess of 100 m with negligible loss of signal quality or power.

Features:

• Instrumentation grade pre-amplifier.
  
• balanced input and balanced output.
  
• Can be used with long cable runs with minimum losses.
  
• P48V phantom powered.

Specifications

• Gain: +20 dB.
  
• Input Level (nominal): 1 mV.
  
• Output Level (nominal): 10 mV.
  
• Frequency Response: 20 Hz ~ 20 kHz (-3 dB).
  
• Input impedance: 100 kÙ balanced per arm.
  
• Output Impedence: 100 Ù balanced.
  
• Noise: -116 dB A-Wt RTI.
  
• Maximum Input: 0.8 Vp-p.
  
• Maximum Output: + 11.4 dBu @ 1% THD (8 Vp-p).
  
• Input Connector: XLR 3 PIN Female.
  
• Output Connector: XLR 3 PIN Male.
  
• Pin Assignment: Pin 1 GND, Pin 2 Signal(+), Pin 3 Signal(-).
  
• Current Consumption: 3 mA @ 48V.
  
• Weight: 73.8 grm