RME AEB4-I Analog Expansion Boards for Hammerfall Series Details
The AEB4-I (Analog Expansion Board) adds 4 analog inputs in professional quality to all ADAT capable RME cards (see below). Level adjustment +4 dBu/-10 dBV, 107 dBA SNR and a servo balanced input circuit deliver perfect sound and sonic clarity.

The AEB4-I is designed for maximum flexibility. Both stereo inputs 1/2 3/4 are automatically copied to channels 5/6 and 7/8. Installation is done in a convenient manner using the supplied bracket, or - as no contact to any slot on the motherboard is needed - at any place inside the computer. Nuts for all TRS jacks and a drilling template are included

RME AEB4-I Analog Expansion Boards for Hammerfall Series Specifications

• Input AEB4-I 4 x 1/4" TRS jack, servo balanced
  
• Dynamic ratio 104 dB (RMS unweighted), 107 dBA
• THD+N -95 dB (0.0017 %)
• Frequency response -0.1 dB: 10 Hz - 21 kHz
• Input level for 0 dBFS @ +4 dBu: +12 dBu
• Input level for 0 dBFS @ -10 dBV: +2 dBV
• Crosstalk > 110 dB
• Supported sample rates 32 kHz - 48 kHz Input impedance 10 kOhm
• Power supply uses 3.5" floppy connector, 12 V/5 V DC, 190 mA
• AEB needs no slot on the motherboard
• Standard bracket, board dimensions AEB4: 85 x 95 mm, AEB8: 120 x 95 mm
• 1 internal cable 2-pin, 1 internal cable 3-pin, 1 power adapter cable 5 1/4" to 2 x 3.5" included

HDSP 9652

Two AEBx-I and two AEBx-O or two TEB can be connected and operated simultaneously, in all possible combinations. One TEB can be used together with either one AEBx-I or AEBx-O.

DIGI96 SERIES
AEBs use the internal ADAT interface of the DIGI cards. Therefore they do not work with the DIGI96 (which did not support ADAT.) To operate the AEB4-I and AEB8-I the used DIGIs must have the connectors ST6/7 on board (for the Word Clock Module.) These were not present on the very first cards of the DIGI96 series (1998 to beginning of 1999.

One AEBx-I and one AEBx-O can be connected and operated simultaneously, in all possible combinations. Or one TEB.

HAMMERFALL DSP MULTIFACE / DIGIFACE
Multiface and Digiface use the Hammerfall DSP PCI card. This card has no internal inputs or outputs. Therefore no Expansion Boards can be used.

HAMMERFALL SERIES
An operation with the Hammerfall or Hammerfall Light requires board revision 1.5 or higher, because the internal connectors ADAT1Out, ADAT2Out and ST7 were not implemented in earlier versions.

One AEBx-I and two AEBx-O can be connected and operated simultaneously, in all possible combinations. Or one TEB and one AEBx-O.