AKG CU400 Charging Unit for WMS40 PRO, WMS400 and WMS450 Details
Any wireless microphone system depends on sufficiently charged batteries in all the transmitters. There is nothing more embarrassing than a transmitter running out of juice in the middle of the show, or a voice fading as the transmitter battery dies.
The CU 400 charging unit puts an end to this kind of hassle. It can charge two batteries simultaneously to full capacity within one hour, and there is no risk of overcharging the batteries.
And what's best, you can leave the batteries inside the WMS 40 or WMS 450 transmitters. The transmitters and charger use integrated charging contacts so all you have to do is plug the transmitters into the CU 400 charging unit and remove them after charging.
AKG CU400 Charging Unit for WMS40 PRO, WMS400 and WMS450 Specifications
The charger shall be housed in a rugged plastic case with two multifunctional charging slots for charging WMS 450 and WMS 40 PRO Series wireless transmitters. Each charging slot shall accommodate a handheld or bodypack transmitter and the charger shall be capable of charging any combination of transmitters (e.g., one HT 450 and one PT 450 simultaneously). The batteries shall remain inside the transmitter(s) during charging. The charger shall detect any dry (non-rechargeable) battery inside a transmitter and automatically stop the charging cycle if a dry battery is inserted. A status LED shall be placed in front of each charging slot. These tricolor (red/amber/green) LEDs shall indicate the charger's current operating status: amber - battery is being tested; red - battery is being charged; green - battery is fully charged and charging cycle finished; flashing red - error. The voltage and temperature shall be monitored during the charging cycle and a signal given at the end of a charging cycle to indicate that full capacity has been reached. All required safety parameters shall be monitored and the charging cycle stopped if one or more safety parameters fall below or exceed the acceptable range. Operating voltage shall be 5 VDC, 1.5 A max. The charger shall accept NiMH or NiCd rechargeable batteries with a minimum capacity of 1500 mAh. Typical charging current shall be 1.4 A when one charging slot is used and 0.7 A when both slots are used simultaneously, typical charging time 1.5 hours when one charging slot is used and 3 hours when both slots are used simultaneously (depending on battery type and capacity). The charger shall measure 188 x 115 x 78 mm (LxHxD), weigh approx. 420 g, and be enameled black.
Click here to view all AKG products
